The Trifecta Trigger glue gun comes was designed with a dual temperature switch. The glue gun accepts adapters for Makita battery.
The red light setting is a standard temperature of 195°C. This setting is very similar to traditional high temp glue guns and will give the glue you use a similar feel and function to standard electric powered glue guns. However, by moving the on/off switch the opposite direction to the blue light setting, the glue gun will run at a reduced temperature.
This “Eco Mode” is designed to be hot enough to allow the various adhesives to perform well, but greatly extend the battery run time of the tool.
For instance, in the Eco setting the run time of a fully charged lithium-ion battery can be up to three times the run time of the tool in the red or high temp setting.
Other unique features include time tested durable feed design, extension nozzle for a clear view of glue placement, heat up time in either setting of 3 minutes.
Attention: Makita battery not included.
Recommendations on how to use your glue gun:
- You must allow the glue guns to heat for 3 minutes minimum before attempting to dispense glue
- Do not remove partially used glue sticks when switching to a new stick. Fully dispense the glue by pushing a new stick behind.
- If the glue gun doesn’t dispense, there may be air within the heater. This often happens if you try to dispense the glue before it’s fully heated up. The solution is to tip the glue gun on it’s back, heat the gun for 3 minutes at full power and slowly pully the trigger. You should hear air escaping, along with the glue starting to dispense.