Dentcraft Tools
- One stop shop
- Largest collection of tools
- Fast delivery
Compare products Delete all products
You can compare a maximum of 3 products
Bullet tip with hard red PVC 8/16" (12,70 mm) working diameter
Bullet tip with hard red PVC 4/16" (6,35 mm) working diameter
S Hook
Wire Hand tool Set - 6 pcs
Extension 1,5" (3,81 cm)
Door Compliment Set - 12 pcs
Set Hammer head whale tails
Double bend door rod 36" (91 cm), 7/16" (1,11 cm) diameter
Mini Fender rod Set - 4 pcs
Knockdown hammer with interchangeable tip 22" (55,8 cm)
This 22 inch Knock Down hammer comes with interchangeable tips on both sides of the hammers. All standard interchangeable tips will fit these hammers. The hammer comes with B4-p tips and a flat surface. More information
Extra Giant Whale tail 24" (61 cm)
24 inch extra giant whale tail with a 2 inch head (Green/Gray). More information
Ultra thin Whale Tail 30" (76 cm) with 1/2" (1,27 cm) wide head
Shaved tool Set - 6 pcs
Bullet tip 2/16" (3,18 mm) working diameter
Wide Whale Tail Set with 1-1/2" tip - 6 pcs
Reverse Handle Whale Tail 54" (137 cm)
Reverse Handle Whale Tail 54 inch (1,37 m) (Lime/Black) More information
Wide Whale Tail Standard 54" (137 cm) with 1-1/8" (2,86 cm) wide head
1-1/8 inch Wide Whale Tail (Standard) 54 inch (137,16 cm) long More information
Half inch tip with hard red PVC 12/16" (19,05 mm) working diameter
Brace tool Left 10" (25 cm), .125" diameter
Length 10 inch (25,4 cm) and 0,150 inch (3,81 mm) diameter.
The angle bend on the tip is 90 degrees. The length of the flag is 1 inch (2,54 cm). More information
Side Panel Hook 30" (76 cm), .362" diameter with 3-1/2" (9 cm) curved flag
30 inch (76,2 cm) long side panel hook tool with 3 1/2 inch (7,62 cm) curved flag and .362 inch (9,2 mm) diameter tip. More information
Round tip 4/16" (6,35 mm) working diameter
Super Glue Cutter
This tool is made exclusively for Dentcraft tools. The intention is to cut glue away from braces for access to panel surface. More information
Brace tool Right 18" (45 cm), .243" diameter
Length 18 inch (45,7 cm) and 0,243 inch (6,17 mm) diameter.
The angle bend on the tip is 45 degrees. The angle bend on the shaft is 10 degrees. The length of the flag is 1-1/2 inch (3,8 cm). More information